Dual Carb Rebuild
When I got the bike I didn’t know if it was jetted or not. It came with drag pipes, so I thought It might have been jetted, but of course theres only one way to find out! Below are the steps that I went through cleaning my first ever carb following the Haynes manutal. It did have a bit of rust dust, but overall, it was in pretty good condition. If you see a needed edit, please let me know and I’ll be glad to change it.
Left Side
Right Side
Top view
Airbox Removed
Right Side Hoses
Coolant Hose Disconeected
Left Airbox Boot
Right Airbox boot
Breather hose (right side)
Breather hose removed
Throttle cover plate
Throttle plate. Tip: remove the circled bold on the left first, then the circled bolt on the right, then the cables. It is MUCH easier to remove the throttle cables AFTER the throttle plate is disconnected from the carbs.
After some finagleing, creative angling and maneuvering, the carbs come out. pulling up the wire tab helps.
Left Side
Right Side
Front View
Rear View
Choke cable
Choke cable
Diaphragm cover